All values measured to ground unless otherwise noted
Conn./Plug/Pin	Pin Information	Test Value	Comments
N7
1.4 1.5	Circuit 56b voltage supply output, Right front low beam lamp Left front low beam lamp	Lights on, S1 in pos. II, S4 in low beam pos. 12 VDC	Note
2.7 2.8	Circuit 58, left taillamp voltage supply auxiliary taillamp tail/parking lamp	Engine running 12 VDC or Lights on, S1 in pos. I or II, 12 VDC	Feed from S1 pin10 via F1f16 to pin 3.7 Note
2.15 2.16	Circuit 58, right taillamp voltage supply auxiliary taillamp tail/parking lamp	Lights on, S1 in pos. I or II, 12 VDC	Feed from S1 pin 3 via F1f15 to pin 3.16
3.1 3.2	Circuit 56b, fused voltage input, left low beam right low beam	Engine running 12 VDC or Lights on, S1 in pos. II, S4 in low beam pos. 12 VDC	Feed from either S1 pin1 via S4s3 or N35 pin7 Note
3.7	Circuit 58, left tail/parking lamp fused voltage input	Engine running 12 VDC or Lights on, S1 in pos. I or II, 12 VDC	Note
3.13	Main ground to W1	Approx. 0 Ohms to ground
3.14	Circuit 61e voltage decoupled signal input	12 VDC with generator running	Feed from generator via IC
3.16	Circuit 58, right tail/parking lamp fused voltage input	Engine running 12 VDC or Lights on, S1 in pos. I or II, 12 VDC	Note
N35			Note
1 2	Circuit Ke, license plate lamp voltage output lights on feedback input from F1/1f9	Engine running, S1 in pos. 0 12 VDC
3	Circuit 61e voltage decoupled signal input, activates "lights on" relays in N35	Engine running, S1 in pos. 0 12 VDC Daytime running lamps on	see pin5
4	Circuit 30 main power input	12 VDC all times
5	Circuit 15 relay voltage supply high side, enables "lights on" relays in N35	Ignition o n 12 VDC	relays are activated by circ. 61 (see pin3)
6	Circuit 50 starter lockout voltage, lights on inhibit signal input	Start engine 12 VDC while starter cranks Engine running <2 VDC	Lights not on Lights on
7	Circuit 56b low beam voltage supply output,	Engine running, S1 in pos. 0 12 VDC	low beam lights on
8	Pin not used
9	Main ground to W1	Approx. 0 Ohms to ground
10	High beam lights on signal input deactivates low beam relay in N35	Engine running low beam mode < 2VDC switch S4 to high beam pos. 12 VDC
11 12	Circuit 58 taillamp voltage supply output left taillamp right taillamp	Engine running, S1 in pos. 0 12 VDC	Feed to F1f16 Feed to F1f15
Note	daytime running light feature switches on Marker lamps Low beam headlamps Taillamps License plate lamps as soon as engine is running	The daytime running light function is canceled by switching on the parking lights or low beam headlamps with exterior light switch S1.