|
All values measured to ground unless otherwise noted
|
| Conn./Plug/Pin |
Pin Information |
Test Value |
Comments |
| N70 |
|
|
|
| A.1 |
Main ground to W19 |
Approx. 0 Ohms to ground |
|
| A.2 |
Circuit 30 power input |
12 VDC at all times |
Feed from F1f9 |
| A.3 |
CAN Class B bus (low side). Mid speed data transfer bus input and output, exchanges data with other ECMs |
No reliable test. Check continuity of wiring. Approx. 5 VAC when data is on bus |
|
| A.6 |
CAN Class B bus (high side) |
See pin A.3 |
|
| B.1 |
Sliding/pop-up roof motor power output |
Ignition on 12 VDC to pin B.2 with sliding/pop-up roof actvated, polarity reversable |
|
| B.2 |
Sliding/pop-up roof motor power output |
See pin B.1 |
|
| B.3 |
Hall sensor 1 signal input |
7.1 - 7.5 VAC (rms voltage) |
|
| B.4 |
Circuit 15R sensors power output |
12 VDC with key in steering lock position "1" |
|
| B.5 |
Hall sensor 2 signal input |
7.1 - 7.5 VAC (rms voltage) |
|
| B.6 |
Circuit 31 sensors ground output |
Approx. 0 Ohms to ground |
|
| Note 1 |
Due to various functions N70 is split up in several system diagrams, therefore only the relating pins are listed. Pins not shown are unrelated to this system |
|
|